Toggle switch SPDT (sub-miniature, THT)
Sub-miniature bat-handle toggle switch, on-none-on (E-Switch 100 series; C&K 7101 class): body 12.7 × 6.86 × 8.89 mm, Ø 6.22 mm bushing, lever 12.2 mm, 28.2 mm tall over the board; three PCB pins at 4.70 mm. Closed: lever towards pin 3, common (2) to pin 1; open: common to pin 3. The arm / mode switch of an RC transmitter. Flip it in the schematic, the inspector or the World view while the simulation runs.
Key data
- Category
- Switches
- Simulation model
- Built-in circuit element
- Manufacturer part number
- 100SP1T1B4M2QE
- Reference prefix
- SW
- Pins
- 3
- Land pattern
- SW_Toggle_SPDT_E-Switch_100SP_P4.70mm
- Interactive
- Click it while the simulation runs
Simulation model
Changeover switch: common to the first throw while closed, to the second while open, each contact with its on-resistance. Click it while the simulation runs.
- Primitive
- SPDT
Pins 3
| Pin | Name | Use |
|---|---|---|
| 2 | COMPassive pin | Contact: carries a signal or supply wire |
| 1 | 1Passive pin | Contact: carries a signal or supply wire |
| 3 | 3Passive pin | Contact: carries a signal or supply wire |
Parameters 3
closedLever in position 3: common (2) to pin 1. Off: lever in position 1, common to pin 3.
RonContact resistance (E-Switch 100 series: 10 mΩ max. initial)
massNot in the E-Switch drawing: ~4 g estimated (brass bushing and lever, case, steel frame; the C&K 7101 with threaded bushing and nut is listed at 5.1 g). Counts for the mass of its board.
PCB
SW_Toggle_SPDT_E-Switch_100SP_P4.70mm| Package | Land pattern | Status | Source |
|---|---|---|---|
| · 100SP1T1B4M2QE | SW_Toggle_SPDT_E-Switch_100SP_P4.70mm | Verified land pattern | E-Switch 100SP1T1B4M2QE drawing T111597 rev G: recommended PCB layout 3 × Ø 1.85 mm at 4.70 mm, body 12.70 × 6.86 mm |